Monitor and Maintain the Adapter
27
A6210 WiFi USB Adapter
For more information about letting your adapter join a network, see Join a WiFi Network on
page 11.
3. If NETGEAR genie is not yet open, click the icon in the system tray or on your desktop.
The NETGEAR genie Home screen displays.
4. Click the Other button.
The Other screen displays.
The screen shows the following information:
• Sent/Received Activity. The total number of packets sent or received during
communication with the WiFi network.
• Network. The following information about the adapter’s network displays:
- IPv4 Address. The IPv4 address that is assigned to the adapter.
The IPv4
address can change if you disconnect from the network and rejoin it later.
- IPv6 Address.
The IPv6 address that is assigned to the adapter. The IPv6
address can change if you disconnect from the network and rejoin it later.
- Security Type. WiFi security used for the adapter to connect to the current WiFi
network.
• Adapter:
The following information about the adapter displays:
- Adapter MAC Address
. The adapter’s Media Access Control (MAC) address.
The MAC address is a unique 48-bit hardware address assigned to each device.
As a security measure, some WiFi networks restrict access based on a list of
known MAC addresses. If you try to join such a network, you must provide your
adapter’s MAC address (shown on this screen) to the network administrator
before you can connect.
- Region.
The adapter’s region setting. WiFi channels in use depend on the
country or region. The adapter automatically scans approved channels for your
To Next Page
Loading...
Need help?
General
