ADT Pulse Wi-Fi Range Extender
https://alpha.adt.com/help/108[11/12/2018 10:11:06 PM]
16. Remove the Ethernet cable, and then unplug the Wi-Fi Extender from the electrical outlet.
17. Locate the Wi-Fi Extender to its permanent position and plug it into an electrical outlet. Within a few
minutes of plugging it back in, the ADT Pulse system recognizes the extender and places it back online.
Factory Reset
Pulse Wi-Fi Range Extender
How to Perform a Factory Reset:
During the enrollment process, you may be requested to restore the Wi-Fi Extender to its factory default
settings. To reset the device, press the Factory Reset button on the Wi-Fi Extender. The power LED
changes from solid green to solid amber. Continue pressing the reset button until the power LED flashes
amber, and then release. The device reboots and the settings are restored to their default values.
The Reset button is recessed in a small opening and requires the use of a paper clip to reach it. The
To Next Page
Loading...
Need help?
General