NETGEAR AX4200 User Manual

Top panel LEDs and buttons
The status LEDs and two buttons are located on the top panel of the router.
Figure 2. Top view
Table 1. LED descriptions
DescriptionLED and Button
•
Solid white. The router is ready.
•
Blinking white. The router is not ready, firmware is upgrading, or the Reset
button was pressed.
•
Off. Power is not supplied to the router.
Power LED
•
Solid white. The Internet connection is ready.
•
Blinking white. The port is sending or receiving traffic.
•
Off. No Ethernet cable is connected between the router and the modem.
Internet LED
User Manual10Hardware Setup
Nighthawk AX5 5-Stream AX4200 WiFi Router

NETGEAR AX4200 Specifications

General

WiFi Technology	WiFi 6 (802.11ax)
WiFi Performance	AX4200
Number of Bands	Tri-Band
Combined Speed	4.2 Gbps
USB Ports	1 x USB 3.0
Antenna	6 internal antennas
MU-MIMO	Yes
OFDMA	Yes
Beamforming	Yes
Ethernet Ports	1 WAN + 4 LAN Gigabit Ethernet ports
Security	WPA3
Memory	512MB RAM and 256MB Flash