Wireless Cable Voice Gateway Model CBVG834G Adminstrators User Manual
Protecting Your Network 3-11
v1.0, February 2008
Forwarding Inbound Traffic
To forward inbound traffic:
1. Select the service that you want to forward from the Predefined Services drop-down list.
If the service that you want to forward is not in the predefined list, you can add a custom
service. Enter the range of ports that you want to forward and select whether the ports are TCP,
UDP or Both.
2. If you want to change the suggested port numbers, enter a new Start Port and End Port.
3. From the drop-down Protocol list, select the protocol: TCP, UDP, or Both.
4. Enter the IP address of the computer on your network to which you would like to direct the
inbound traffic in the Local IP Address field.
5. Click Add. The new Port Forwarding rule is added to the Active Forwarding Rules table.
Deleting a Rule
To delete an existing rule:
1. Select the radio button for the rule that you want to delete.
2. Click Delete to delete the Port Forwarding rule.
Figure 3-7
To Next Page
Loading...
Need help?
General