NETGEAR dg834pn

Wireless ADSL Modem Router Setup Manual
1-2 Connecting the Router to the Internet
v1.0, October 2005
The Router’s Front Panel
The wireless ADSL modem router front panel shown below contains status LEDs.
You can use the LEDs to verify various conditions. Table 1-1 describes each LED.
Figure 1-1
Table 1-1. LED Descriptions
Label Activity Description
1. Dome
On (default)
Off
1-7 antenna lights blink indicating wireless activity.
The antenna lights are turned off.
2. Power
On
Off
Power is supplied to the router.
Power is not supplied to the router.
3. Test
On
Off
The system is initializing.
The system is ready and running.
4. PPP Link
On
Off
The ADSL link is active.
The ADSL link is inactive.
5. Internet
Blink -- Amber
On -- Green
Blink -- Green
Indicates ADSL training.
The Internet port has detected a link with an attached device.
Data is being transmitted or received by the Internet port.
6. Wireless
On
Off
Indicates that the Wireless port is initialized.
The Wireless Access Point is turned off.
7. LAN
On (Green)
Blink (Green)
On (Amber)
Blink (Amber)
Off
The Local port has detected a link with a 100 Mbps device.
Data is being transmitted or received at 100 Mbps.
The Local port has detected a link with a 10 Mbps device.
Data is being transmitted or received at 10 Mbps.
No link is detected on this port.
7
2
34
5
1
6