NETGEAR E X2700 - Connecting to Your Wifi Network

3
SELF-INSTALLATION GUIDE
WIFI ADAPTER
Connecting to
your WiFi network
LED descriptions
Router Link LED
This LED indicates the connections between the WiFi adapter and the router or access point.
Solid green – best connection Solid amber – good connection
Solid red – poor connection Off – no connection
Device Link LED
This LED indicates the connection between the WiFi adapter and a computer or mobile device.
Solid green – best connection Solid amber – good connection
Solid red – poor connection Off – no connection
Power LED
Solid amber – WiFi adapter is booting Solid green – WiFi adapter is on
Off – WiFi adapter is off
WPS LED
Solid green – WiFi security is enabled
(WPA or WPA2)
Blinking green – WPS connection is being
established
Off – WiFi security is not enabled
3WIFI ADAPTER
|
INSTALLATION GUIDE WINDSTREAM
|
1. Place your WiFi adapter in the same room as the WiFi router. Proximity to the WiFi
router is required only during the initial setup process.
2. Plug the WiFi Adapter into an electrical outlet and wait for the Power LED to light green.
3. If the Power LED does not light, press the Power On/O buon on the WiFi Adapter.