NETGEAR EX6100 User Manual

Get Started
14
AC750 WiFi Range Extender
18. If the Router Link LED doesn’t light amber or green, plug the extender into an outlet closer
to the router and try again.
Keep moving the extender to outlets closer to the router until the Router Link LED lights
amber or green.
19. Reconnect your computer or WiFi device to the new extended WiFi network.
20. T
est the extended WiFi range by moving your computer or WiFi device to the area with a
poor router WiFi signal:
a. Leave your computer or WiFi device in the area with a poor router WiFi signal and
return to the extender
.
b. Check the Client Link LED
on the extender:
• If the Client Link LED is solid green or amber
, your extended WiFi network
reaches the area with a poor router WiFi signal and your network setup is
complete.
• If the Client Link LED is red, your extended WiFi network does not reach the area
with a poor router WiFi signal.
You must move the computer or WiFi device closer to the extender until the Client
Link LED turns solid green or amber
.
Connect Ethernet-Enabled Devices
After the extender is connected to your existing WiFi network, you can connect a device to
the extender using an Ethernet cable. Then that device can access your existing network
through the extender-to-router WiFi connection.
WiFi router
Extender
Blu-ray player
Figure 4. Ethernet connection to the extender

NETGEAR EX6100 Specifications

Weight and Dimensions

dimensions	4.80 x 2.91 x 1.50 in (122 x 74 x 38 mm)
weight	0.47 lb (0.213 kg)