Get Started
12
Nighthawk X4 AC2200 WiFi Range Extender
9. Test the extended WiFi range by moving your computer or WiFi device to the area with a
poor router WiFi signal:
a. Leave your computer or WiFi device in the area with a poor router WiFi signal and
return to the extender
.
b. Check the Client Link LED
on the extender:
• If the Client Link LED is solid green or amber
, your extended WiFi network
reaches the area with a poor router WiFi signal and your network setup is
complete.
• If the Client Link LED is red, your extended WiFi network does not reach the area
with a poor router WiFi signal.
You must move the computer or WiFi device closer to the extender until the Client
Link LED turns solid green or amber
.
Connect With the NETGEAR Installation Assistant
To connect with the NETGEAR installation assistant:
1. Connect your device to the extender using a wired Ethernet or WiFi connection:
• T
o connect with a wired Ethernet connection, use an Ethernet cable to connect the
Ethernet port on the extender to an Ethernet port on your computer.
• T
o connect with WiFi, on your WiFi-enabled device, open the WiFi connection
manager and locate and connect to the extender network called NETGEAR_EXT..
After the connection with your WiFi-enabled device is established, the Client Link LED
lights.
2. Launch a web browser
.
3. Enter www
.mywifiext.net in the address field of the browser.
The New Extender Setup page displays.
4. Click the NEW EXTENDER SETUP button.
To Next Page
Loading...
