Monitor and Maintain the Extender
40
Nighthawk X4 AC2200 WiFi Range Extender
5. Select Settings > Other Settings.
CAUTION:
After you click the RESET button, do not try to go online, turn off the
extender, shut down the computer, or do anything else to the extender
until it finishes restarting.
6. Click the RESET button.
A confirmation pop-up window opens.
7. Confirm your decision.
The extender returns to its factory settings and restarts. This process takes about one
minute.
Update the Firmware
Unless you changed the settings on the Firmware Update page previously, the extender is
set up to check for new firmware automatically at login.
To check manually for new firmware and, if available, update the firmware:
1. On your WiFi-enabled device, open the WiFi connection manager and locate and
connect to the new extender WiFi network.
2. Launch a web browser
.
3. Enter www
.mywifiext.net in the address field of the browser.
A login window opens.
4. Enter your user name and password and click the LOG IN button.
The Status page displays.
To Next Page
Loading...
