NETGEAR GS305P - Installation Manual

Installation
Step 1. Connect the equipment.
Connect Port 5 on the switch to your router. Connect Ports 1
–
4 on the
switch to your power over Ethernet (PoE) or non-PoE devices.
5-Port PoE Gigabit Ethernet Unmanaged Switch
GS305P
Step 2. Connect to power.
Step 3. Check the status.
GS305P
Sample connections
Package Content
• Switch
• Power adapter (localized to the country of sale)
• Wall installation kit
• Rubber feet
• Installation guide
Router
Internet
PoE security cameras
PoE access point
PoE VoIP phone
Power LED Le Port LEDs (Ports 1–5) Right PoE LEDs (Ports 1–4)
On 1000 Mbps link PoE in use
O
100 or 10 Mbps link
PoE halted (see PoE
Troubleshooting)
Activity (blinking)
No PoE use (o)
No link (o)
PoE Max LED
The maximum PoE power that the GS305P switch can deliver to all attached powered devices
(PDs) is 55.5 Watts total, with a maximum power to each port of 15.4 Watts. (For more
information, see PoE Considerations.)
The PoE Max LED indicates the status of the PoE power that the switch can deliver to all
attached PDs.
Less than 7W of PoE power is available on the switch (the LED is on).
The PoE Max LED was active in the previous two minutes (the LED is blinking).
Sucient (more than 7W of) PoE power is available on the switch (the LED is o).
Connect Port 5 to the router