NETGEAR GS316P User Manual

Attach the switch to a wall
To attach the switch to a wall, you need the wall-mount screws that are supplied
with the switch.
To attach the switch to a wall:
1. /RFDWHWKHWZRPRXQWKROHVRQWKHERWWRPSDQHORIWKHVZLWFK
2. Mark and drill two mounting holes in the wall where you want to mount the
switch.
The two mounting holes must be at a precise distance of 4.27 in. (108.4 mm)
from each other.
3. Insert the supplied anchors into the wall and tighten the supplied screws with
a No. 2 Phillips screwdriver.
Note: /HDYHDERXWLQPPRIHDFKVFUHZSURWUXGLQJIURPWKHZDOOVR
that you can insert the screws into the holes on the bottom panel.
Change the switch’s PoE budget
You can move the slider on the back of the switch to increase or decrease the
PoE budget. You can increase the PoE budget if you buy a higher wattage power
supply. You also can move the slider to a PoE budget that is lower than the power
supply wattage. This reduces your switch’s power consumption. However, we
recommend using the slider setting that matches your power supply.
1. Power down the switch and disconnect the
power cord.
2. Move the slider to the setting that
corresponds to the wattage of the new
power adapter.
3. Connect the power cord and power on the
switch.

NETGEAR GS316P Specifications

General

Switch type	Unmanaged
Quality of Service (QoS) support	Yes
Power connector	DC-in jack
Installed SFP modules quantity	-
Basic switching RJ-45 Ethernet ports type	Gigabit Ethernet (10/100/1000)
Basic switching RJ-45 Ethernet ports quantity	16
10G support	No
Networking standards	IEEE 802.1p, IEEE 802.3, IEEE 802.3ab, IEEE 802.3az, IEEE 802.3i, IEEE 802.3u, IEEE 802.3x
Jumbo frames	9216
Latency (1 Gbps)	3.7 µs
MAC address table	4000 entries
Packet buffer memory	1 MB
Packet forwarding rate (1 Gbps)	1448000 pps
Heat dissipation	437.42 BTU/h
Operating altitude	0 - 3000 m
Storage temperature (T-T)	-20 - 70 °C
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	0 - 90 %
Input current	2.4 A
DC input voltage	54 V
Power consumption (max)	127.9 W
Mean time between failures (MTBF)	2362192 h
Product color	Black
Housing material	Metal
Harmonized System (HS) code	85176990

Weight and Dimensions

Depth	102 mm
Width	286 mm
Height	27 mm
Weight	880 g