NETGEAR GS716TP - Page 26

To check the package contents:
1.
Place the container on a clean flat surface, and cut all straps securing the container.
2.
Unpack the hardware from the boxes by carefully removing the hardware and placing
it on a secure and clean surface.
3. Remove all packing material.
4.
Verify that the package contains the following items:
ItemNumber
Model GS716TP or model GS716TPP switch.
1
AC power cable (varies by region).
2
Screws for rack-mounting:
•
Eight small screws to attach the brackets to the switch (four small screws for each side).
•
Four large screws to attach the brackets to the rack (two screws for each side).
3
Two brackets for rack-mounting.
4
Installation guide.
5
Rubber protection caps, which are already installed in the SFP sockets. If you install an SFP
transceiver module, you must remove the cap from the SFP socket.
6
Rubber feet for desktop or table installation.
7
5.
If any item is missing or damaged, contact your local NETGEAR reseller for
replacement.
Hardware Installation Guide26Installation
16-Port Gigabit (Hi-Power) PoE+ Ethernet Smart Managed Pro Switch with 2 SFP Ports