NETGEAR M4300-52G User Manual

PoE power budgets............................................................................45
Chapter 3 Installation
Step 1: Prepare the site......................................................................48
Step 2: Protect against electrostatic discharge..............................48
Step 3: Unpack the switch.................................................................49
Step 4: Install the switch....................................................................51
Install a full-width switch in a rack................................................51
Install a single half-width switch in a rack...................................52
Install two half-width switches in a rack.......................................54
Install the switch on a flat surface.................................................56
Optional Step 5: Install SFP transceiver modules...........................56
Install an SFP transceiver module in a full 10G model..............56
Install an SFP transceiver module in an uplink or combo port..57
Optional Step 6: Install a power supply unit...................................58
Optional Step 7: Connect a redundant power supply to model
M4300-52G-POE+..............................................................................59
Step 8: Check the installation...........................................................60
Step 9: Apply AC power and check the LEDs.................................61
Optional Step 10: Connect a console to the switch.......................62
Chapter 4 Maintenance and Troubleshooting
Replace a power supply unit.............................................................65
Replace a half-width switch in a rack................................................66
Troubleshooting chart.......................................................................68
Additional troubleshooting suggestions.........................................69
5
M4300 Intelligent Edge Series Fully Managed Stackable Switches

NETGEAR M4300-52G Specifications

General

Switch type	Managed
Switch layer	L3
Stackable	Yes
Form factor	1U
Product color	Black
Console port	RS-232
SFP+ module slots quantity	2
Installed SFP+ modules quantity	0
Basic switching RJ-45 Ethernet ports type	Gigabit Ethernet (10/100/1000)
Basic switching RJ-45 Ethernet ports quantity	48
Output power	150 W
Power consumption (max)	47.4 W
Number of power supply units	1
Number of VLANs	4000
Networking standards	-
MAC address table	16000 entries
Packet buffer memory	16 MB
Memory type	RAM
Noise level	31.5 dB
Flash memory	256 MB
Internal memory	1024 MB
Processor frequency	800 MHz
DHCP features	DHCP server
Security algorithms	802.1x RADIUS, HTTPS, SNMP

Weight and Dimensions

Weight	4910 g