Need help?Do you have a question about the NETGEAR M4250-26G4XF-PoE+ and is the answer not in the manual?
Step-by-step instructions for initial login using the default IP address.
Instructions for accessing the AV UI using the Out-of-Band (OOB) port.
Step-by-step process to create and assign network profiles using templates.
Detailed steps for creating custom AV profile templates with specific settings.
Step-by-step guide to creating a Link Aggregation Group (LAG).
Details PoE capabilities, budgets, and management of interface settings.
Step-by-step guide to creating custom PoE power schedules.
Introduces port-based authentication and its components.
Guides on assigning specific authentication modes to ports.
Steps to enable or disable global 802.1X access authentication.
Explains the role of RADIUS servers in network security.
Guides on setting up IP addresses and keys for RADIUS servers.
Steps to activate a license key over the internet.
Procedures to activate a license key using an offline file.
Guides on updating the switch's firmware using a file.
Instructions to save the current configuration to startup.
Explains the management interface IP and how to configure it.
Steps to assign a static IP address to the management interface.
Details the Out-of-Band (OOB) port IP address and its configuration.
Guides on assigning a static IP address to the OOB port.
Instructions to reboot the switch using the AV UI.
Steps to revert the switch to its original factory settings.
How to enable/disable and configure logging for switch events.
Guides on performing network diagnostic tests like ping and traceroute.
How to test the integrity of connected Ethernet cables.
To Next Page
General