Need help?Do you have a question about the NETGEAR ProSAFE M4300 series and is the answer not in the manual?
General| Stackable | Yes |
|---|---|
| Series | ProSAFE M4300 |
| Layer | L3 |
| Ports | Varies by model (24, 48 ports) |
| PoE | Available on some models (PoE+) |
| Management | Web, CLI, SNMP |
| Redundancy | Yes (dual power supplies on select models) |
| Form Factor | Rack-mountable |
| Throughput | Varies by model |
| Switching Capacity | Varies by model |
| Jumbo Frame Support | Yes |
| VLAN Support | Yes |
| Quality of Service (QoS) | Yes |
| Security Features | ACLs, 802.1x |
| Dimensions | Varies by model |
| Weight | Varies by model |
| Operating Temperature | 0° to 50° C (32° to 122° F) |
| Storage Temperature | -4°F to 158°F (-20°C to 70°C) |
| Humidity | 95% relative humidity, non-condensing |
| Power Supply | Varies by model |
| Warranty | Lifetime |
Outlines essential safety precautions for installation and operation to prevent injury and damage.
Outlines site requirements, including mounting, access, power, cabling, and environmental conditions.
Provides essential steps to prevent static damage to components during handling and installation.
Covers the process of installing the switch, either on a flat surface or in a rack.
Details the procedure for installing a full-width switch into a 19-inch rack.
Explains how to install a single half-width switch into a rack space.
Describes the method for installing two half-width switches in a single rack space.
Lists common symptoms, their causes, and recommended solutions for troubleshooting issues.
To Next Page