NETGEAR ProSAFE M4300 series - Factory Defaults Button; Power Supply Units

interface on model M4300-52G-POE+ provides a receptacle for an RPS cable such as the NETGEAR DC
Connection Cable Model RPSC5412.
Factory Defaults Button
The switch provides a Factory Defaults button on the front panel so that you can return the switch to its
factory settings.
To return the switch to its factory default settings:
1. Insert a device such as a straightened paper clip into the opening.
2. Press the recessed Factory Defaults button for about three seconds.The switch reboots and returns
to its factory settings.
Power Supply Units
The following table describes the power supply units (PSUs) and options. For model M4300-28G-POE+
and model M4300-52G-POE+, the PSU that is installed depends on the product ordered. For models that
can support two PSUs, you can order a second PSU as an option.
Table 4. Supported PSUs
RPS SupportPower RedundancyPossible PSU ConfigurationsSwitch Model
1x APS250WM4300-8X8F
1x APS250WM4300-12X12F
• 1x APS250W2x
• APS250W
M4300-24X24F
• 1x APS250W2x
• APS250W
M4300-28G
• 1x APS250W2x
• APS250W
M4300-52G
N+1 redundancy
• 1x APS550W
• 2xAPS550W
• 1x APS1001x
• 2x APS1000W
1x APS550W + 1x APS1000W
(see Note)
M4300-28G-POE+
Hardware Overview
33
Managed Stackable Switch Series M4300