NETGEAR ProSAFE M4300 series - Install a Single Half-Width Switch in a Rack

The following figure shows model M4300-52G-POE+. However, you install the other full-width models
in the same manner.
Install a Single Half-Width Switch in a Rack
To install a single half-width switch in single rack space, you need the 19-inch rack-mount kit supplied with
the switch. The figures in the following procedure shows model M4300-24X. However, you install the other
half-width models in the same manner.
To install a single half-width switch in a single rack space:
1. Attach the supplied brackets to the switch:
a. Attach the supplied regular mounting bracket to the side of the switch that you want to attach to the
rack.
b. Attach the supplied long mounting bracket to the other side of the switch.
Installation
41
Managed Stackable Switch Series M4300