Chapter 1: Connecting to the Internet | 17
Mobile Broadband 11n Wireless Router MBR1000 User Manual
Table 3. Mobile Broadband Settings Fields
Fields and Check Boxes Description
User Name Internet account login user name.
Password Internet account password for authentication.
Country Select your country from the drop-down list.
Internet Service Provider Select your Internet Service Provider from the drop-down list.
Access Number The remote site's phone number.
PIN code Pin code of the SIM card, where applicable.
APN Access point name.
PDP type Select the type of packet data protocol:
• IP
• PDP-IP
• PPP
• PPP-IP
Connect automatically at startup When this check box is selected, the modem automatically connects
to the network when powered up. This should be selected after login
information is provided.
Reconnect automatically when
connection is lost
When this check box is selected, the modem will attempt to
reconnect to the network when the connection is lost. Under normal
situations, this setting should be selected.
Roaming automatically When this check box is checked, the unit might roam to any available
operator in range and might incur roaming charges.
Use internal antenna If this check box is selected, the router will use the internal antenna
rather than the external antenna.
Wireless Button Configuration Select the option to determine the behavior of the WPS push button
on the front panel when pressed.
• Control Wi-Fi Only: Pressing the push button toggles the Wi-Fi
function. If Wi-Fi is turned on, pressing the push button turns off
the Wi-Fi. Pressing it again will turn on the Wi-Fi. This function is
available only if the Wi-Fi function is enabled. The Wireless
Broadband function is unaffected.
• Control Both Wi-Fi and Wireless Broadband: Pressing the
push button toggles both the Wi-Fi function and wireless
broadband at the same time. If Wi-Fi is turned on, pressing the
push button turns off the Wi-Fi. At the same time, the wireless
broadband connection is disconnected. If you press the push
button again, Wi-Fi is turned on and the router attempts to
re-establish the wireless broadband connection. Depending on
the coverage, wireless broadband coverage might or might not
be connected successfully.
Connection status Current WAN port status.
To Next Page
Loading...
