Chapter 5: Advanced | 71
Mobile Broadband 11n Wireless Router MBR1000 User Manual
LAN Setup
The LAN Setup screen allows configuration of LAN IP services such as DHCP and RIP.
These features can be found under Advanced in the router main menu.
The router is shipped preconfigured to use private IP addresses on the LAN side, and to act
as a DHCP server. The router default LAN IP configuration is:
• LAN IP address. 192.168.0.1
• Subnet mask. 255.255.255.0
These addresses are part of the Internet Engineering Task Force (IETF)–designated private
address range for use in private networks, and should be suitable in most applications. If your
network has a requirement to use a different IP addressing scheme, you can make those
changes in this screen.
Tip: If you change the LAN IP address of the router while connected through
the browser, you will be disconnected, and so will others connected to
the router. To connect to the router, you must open a new connection to
the new IP address and log in again. Others using the router must restart
their computers to connect to the router again.
To view or change the LAN setup:
1. Select LAN IP to display the LAN Setup
screen.
2. Change the settings. For more information,
see
Table 15, DHCP Settings on page 72 or
Reserved IP Addresses on page 73.
3. Click Apply to save the changes.
To Next Page
Loading...
Need help?
General
