34 | Chapter 2: Wireless Network Configuration
Mobile Broadband 11n Wireless Router MBR1000 User Manual
• Change the wireless network name (SSID) to a meaningful name.
• On the WPA/PSK + WPA2/PSK screen, select a passphrase.
• Make sure that the Keep Wireless Settings check box is selected in the WPS
Settings screen so that your new settings will not be erased if you use WPS.
4. Click Apply so that your changes take effect. Write down your settings.
All existing wireless clients are disassociated and disconnected from the router.
5. For the non-WPS devices that you want to connect, open the networking utility and follow
the utility’s instructions to enter the security settings that you selected in Step 3 (the SSID,
WPA/PSK + WPA2/PSK security method, and passphrase).
6. For the WPS devices that you want to connect, follow the procedure WPS Button on
page 31 or WPS PIN Entry on page 32.
The settings that you configured in Step 3 are broadcast to the WPS devices so that they
can connect to the router.
To Next Page
Loading...
