EasyManua.ls Logo

NETGEAR MBR1200 - Page 48

NETGEAR MBR1200
108 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
48 | Chapter 4: Managing Your Network
Mobile Broadband 11n Wireless Router MBR1000 User Manual
Table 8. Router Status Fields
Field Description
Firmware Version This field displays the router firmware version.
Mobile Broadband Modem Identity Shows the modem in use.
Modem sw version The software version of the modem.
Modem driver
version
The driver version of the modem.
IMSI International Mobile Subscriber Identity. SIM card identity.
IMEI International Mobile Equipment Identity.
Unique identity of the modem.
Operator The ISP for the broadband wireless network.
Network mode The mode of the current network the modem is connected to.
This is dependent on coverage and distance from the cell site.
WAN Port Connection Status The status of the Internet connection.
IP Address The IP address used by the modem. If no address is shown,
the router cannot connect to the Internet.
Protocol The protocol for the Internet connection, which is PPP
(Point-to-Point).
IP Subnet Mask The IP subnet mask used by the router’s USB port.
Gateway IP Address The IP address used by the router.
Domain Name
Server
The DNS server IP addresses used by the router. These
addresses are usually obtained dynamically from the ISP.
LAN Port MAC Address The Ethernet MAC address used by the router’s LAN port.
IP Address The LAN port IP address. The default is 192.168.0.1.
DHCP
Off. The router does not assign IP addresses to PCs on the
LAN.
On. The router assigns IP addresses to PCs on the LAN.
IP Subnet Mask The LAN port IP subnet mask. The default is 255.255.255.0.
Wireless Port
(See Manually
Configuring
Your Wireless
Settings on
page 27.
Name (SSID) The service set ID, also known as the wireless network name.
Region The country where the unit is set up for use.
Channel The current channel, which determines the operating
frequency.
Wireless AP Indicates if the access point feature is disabled or not. If not
enabled, the Wireless LED on the front panel will be off.
Broadcast Name Indicates if the router is configured to broadcast its SSID.

Table of Contents

Other manuals for NETGEAR MBR1200

Related product manuals