90 | Chapter 6: Troubleshooting
Mobile Broadband 11n Wireless Router MBR1000 User Manual
Internet Port Internet LED is red. The router cannot connect to the Internet. Check the Internet connection
option being used.
• For the mobile broadband connection option, check the Signal LED.
• For the Ethernet connection option, check the WAN LED.
Internet LED is
blinking red and
green.
The Traffic Meter feature is enabled, and the limit set has been reached.
Wi-Fi Wi-Fi LED is off. The Wi-Fi radio has been turned off. If you want a Wi-Fi connection with the
router, push the Wi-Fi button to turn the Wi-Fi radio back on.
Wi-Fi LED is not
blinking.
If this LED does not blink when you are attempting to send data over the
Wi-Fi link, log in to the router menu using the Ethernet LAN connection and
check your router’s wireless (Wi-Fi) configuration.
LAN Ports LAN LED is off. If this LED does not light when an Ethernet connection is made, check the
following:
• Make sure that the Ethernet cable connections are secure at the router
and at the hub or workstation.
• Make sure that power is turned on to the connected hub or workstation.
WAN Port WAN LED is off. If this LED does not light when an Ethernet connection is made using the
Ethernet connection option, check the following:
• Make sure that the Ethernet cable connections are secure at the router
and at the modem.
• Make sure that power is turned on to the modem.
2G/3G 2G/3G LED is off. The router cannot tell if the mobile broadband connection uses 2G or 3G
signals.
Signal Signal LED of off. If this LED does not light when the Mobile Broadband connection option is
used, check the following:
• Check with your ISP to ensure that there is good coverage in the area.
• Ensurethat your mobile broadband account is active.
• Ensure that the SIM card is inserted correclty into the router.
• Locate the router near the window or other area of the building. Make
sure that the Signal LED is lit, indicating that there is mobile broadband
coverage with the router.
• Log in to the router menu and check your router’s Internet configuration.
Check that the user name, password, and APN with ISP are set
correctly. If you use a PIN to connect to the Internet, make sure that it
is entered correctly.
Table 17. Troubleshooting with the LEDs (Continued)
LED Action
To Next Page
Loading...
Need help?
General
