NETGEAR Nighthawk X6S EX8000 User Manual

Factory Default Settings
To reset the extender to factory default settings, you can use the Reset button on the side panel or you can
log in and click the onscreen RESET button. For more information, see Return the Extender to Its Factory
Default Settings on page 41.
The following table shows the factory default settings.
Table 2. Factory default settings
Default SettingsFeature
EnabledSmart Setup
EnabledWiFi communication
NETGEAR_EXTWiFi network name (SSID)
DisabledSecurity
Auto
1
Transmission speed
Varies by regionCountry/region
802.11a/b/g/n/acOperating mode
54 Mbps/145 Mbps/400 MbpsData rate in the 2.4 GHz band
Disabled by default
(When enabled the data rate is 54 Mbps/177.3 Mbps/400
Mbps/866.7 Mbps)
Data rate in the 5 GHz 1 band
Disabled by default
(When enabled the data rate is 54 Mbps/347 Mbps/800
Mbps/1733 Mbps)
Data rate in the 5 GHz 2 band
Server and client are enabledDHCP
1
Maximum WiFi signal rate (IEEE Standard 802.11). Actual throughput can vary. Network conditions and environmental
factors, including volume of network traffic, building materials and construction, and network overhead lower actual data
throughput rate.
Supplemental Information
64
Nighthawk X6S AC3000 Tri-Band WiFi Range Extender

NETGEAR Nighthawk X6S EX8000 Specifications

General

WiFi Technology	802.11ac
Number of Ethernet Ports	4
Ethernet Port Type	Gigabit Ethernet
MU-MIMO	Yes
Beamforming	Yes
Smart Roaming	Yes
Smart Connect	Yes
FastLane Technology	Yes
WiFi Performance	AC3000
WiFi Band	Tri-Band
Security	WPA2 wireless security protocols
Weight	1.9 lbs
Operating Temperature	32° to 104°F (0° to 40°C)
Operating Humidity	10% to 90% non-condensing
Storage Humidity	5% to 95% non-condensing
USB Ports	One (1) USB 3.0 port
Storage Temperature	-4° to 140°F (-20° to 60°C)