6.
In the IP Subnet Mask, type the subnet mask of the router.
The IP address and subnet mask identifies which addresses are local to a specific
device and which must be reached through a gateway or router.
The default IP subnet mask is 255.255.255.0.
7. Change the RIP settings.
Router Information Protocol (RIP) allows a router to exchange routing information
with other routers.
a.
Select a setting from the RIP Direction menu:
•
Both: The router broadcasts its routing table periodically and incorporates
information that it receives.
•
Out Only: The router broadcasts its routing table periodically.
•
In Only: The router incorporates the RIP information that it receives.
b.
Select a setting from the RIP Version menu:
•
Disabled: This is the default setting.
•
RIP-1: This format is universally supported. It is adequate for most networks,
unless you are using an unusual network setup.
•
RIP-2: This format carries more information. Both RIP-2B and RIP-2M send
the routing data in RIP-2 format. RIP-2B uses subnet broadcasting. RIP-2M
uses multicasting.
8. Click the Apply button.
Your settings are saved.
If you changed the LAN IP address of the router, you are disconnected when this
change takes effect.
9. To reconnect, close your browser, relaunch it, and log in to the router.
Change the employee LAN 2 settings
By default, LAN 2 is assigned to the Employee VLAN profile with ID 20. The default IP
address of LAN 2 is 192.168.20.1.
To change employee LAN settings:
1.
Launch a web browser from a computer or mobile device that is connected to your
Orbi network.
2. Enter orbilogin.com.
User Manual107Manage the LAN and WAN
Settings
Orbi Pro WiFi 6 Mini Router SXR30 and Orbi Pro WiFi 6 Mini Satellite SXS30
To Next Page
Loading...
Need help?
General
