NETGEAR PowerLINE 1010 Quick Start

8
Secure Your Network
¾ To create a secure network:
1. Plug in your new adapters.
2. Wait until the Pick A Plug LED is lit.
3. Press the Security button for two seconds, then press the Security
button on one of the other adapters in your existing network for two
seconds. Both buttons must be pressed within two minutes.
Note: The Security button does not work in power saving mode (see
Troubleshooting Tips on page 10).
Warning: Do not press the Security button on the Powerline adapter
until installation is complete and the adapters are communicating with
each other (indicated by the blinking Power LED). Pressing this button too
soon can temporarily disable Powerline communication. If this occurs, use
the Factory Reset button to return the Powerline adapter to its factory
default settings.
Note: If you want to add another adapter aer creating a secure
Powerline network, perform a factory reset on all of the adapters and then
perform this procedure.

NETGEAR PowerLINE 1010 Specifications

General

Brand	NETGEAR
Model	PowerLINE 1010
Category	Adapter
Language	English