Configure WiFi and QoS Settings
182
ProSAFE Wireless Controller
7. Click the Apply button.
Your settings are saved.
Configure WiFi Settings
During initial setup, you entered your country and region in the General Settings page (see
Configure the General Settings on page 100). Based on your location and environment, the
wireless controller determined the best WiFi settings for the discovered access points and
pushed these settings to your managed access points.
IMPORTANT:
Unless your network and environment require that you use other
WiFi settings, we recommend that you leave the WiFi settings as
they are.
Typically, the default WiFi settings do not need adjustment. Override the WiFi settings only if
a specific need exists, such as when the settings that a device vendor specifies are different
from the default settings. You can configure WiFi settings for the basic profile group and for
advanced profile groups (see Configure WiFi Settings for an Advanced Profile Group on
page 188).
Configure WiFi Settings for the Basic Profile Group
Two requirements exist for you to be able to configure the WiFi settings on the Basic
Wireless Settings page:
• You must disable automatic channel allocation for the radio on the Channel Allocation
page. For information about channel allocation, see Configure Channels on page 195.
• At least one access point must be assigned to the profile group for the radio for which you
want to configure the WiFi settings.
 To configure WiFi settings for the basic profile group:
1. Open a web browser, and in the browser’s address field, type the wireless controller’s IP
address.
By default, the IP address is 192.168.0.250.
The wireless controller’s login window opens.
2. Enter your user name and password.
3. Click the Login button.
The wireless controller’s web management interface opens and displays the Summary
page.
4. Select Configuration > Wireless > Basic > Wireless.
To Next Page
Loading...
Need help?
General
