Installation and Configuration Overview
96
ProSAFE Wireless Controller
Your settings are saved.
13. If your network does not include a DHCP server, configure the wireless controller’s DHCP
server.
For more information, see Manage the DHCP Server on page 106.
14. Click the Apply button.
Your settings are saved.
The connection to the wireless controller is terminated because you changed its IP
address.
15. Reconfigure your computer with an IP address and subnet mask that is in the same
IP subnet as the new IP address of the wireless controller.
16. Log back in to the wireless controller using its new IP address.
Continue with the following section, Roadmap for Configuring Management of Your WiFi
Network.
Roadmap for Configuring Management of Your WiFi
Network
After you perform the initial configuration and change the IP address to an address that is
specific to your network (see Roadmap for Initial Configuration on page 94), you are ready to
configure the wireless controller for management of your WiFi network.
This section is a roadmap only: It provides high-level configuration steps with references to
the sections or chapters that provide detailed configuration steps.
 To configure the wireless controller for management of your WiFi network:
1. Open a web browser, and in the browser’s address field, type the wireless controller’s IP
address.
By default, the IP address is 192.168.0.250.
The wireless controller’s login window opens.
2. Enter your user name and password.
3. Click the Login button.
The wireless controller’s web management interface opens and displays the Summary
page.
4. Register the licenses.
For more information, see Register Your Licenses on page 110.
5. (Optional but recommended) Replace the default certificate with a custom certificate for
certificate-based authentication of the
internal authentication server.
For more information, see Manage Certificates on page 113.
To Next Page
Loading...
Need help?
General
