Controller-Managed Access Points
377
ProSAFE Wireless Controller
4. In the IP Settings section, select the DHCP client disable radio button.
The fields become available. By default, the DHCP client enable radio button is selected
and the access point functions as a DHCP client.
5. In the IP Settings sections, configure the IP address information for the access point in the
network.
6. In the Controller Settings section, configure the IP address for the wireless controller in the
network.
7. If you need to change the management VLAN settings, do so in the Vlan Settings section.
By default, VLAN 1 is the management VLAN and it is untagged, that is, the Untagged
VLAN check box is selected and the Untagged VLAN field also states VLAN ID 1. You
can specify a different VLAN ID for the management VLAN and the tagged or untagged
VLAN.
8. Click the Apply button.
You changes are saved. You must let the wireless controller rediscover the access point
in the network (see Discover Access Points With the Discovery Wizard on page 159).
Reenable the DHCP Client on a Controller-Managed
Access Point
By default, a controller-managed access point functions as a DHCP client. If you disabled the
DHCP client, for example, because the access point required a static IP address setting, you
can reenable the DHCP client and allow the DHCP server in your network to assign an IP
To Next Page
Loading...
Need help?
General
