NETGEAR RangeMax Wireless PCI Adapter WPN311 User Manual
2-9
v3.0, January 2007
b. Restart the PCs.
5. Verify wireless connectivity between your peer devices.
Verify connectivity by using the Ping program:
a. On the Windows taskbar click the Start button, and then click Run.
b. Assuming the target PC is configured with 192.168.0.1 as its IP address, type
ping -t 192.168.0.1 and then click OK.
c. This will cause a continuous ping to be sent to the device with the 192.168.0.1 static IP
address. The ping response should change to “reply.”
At this point the connection is established.
Figure 2-8
Figure 2-4
Note: If you cannot connect, see Chapter 4, “Troubleshooting. Also, for problems
with accessing network resources, the Windows Client and File and Print
Sharing software might not be installed and configured properly on your
computers. See the link to “Internet Networking and TCP/IP Addressing” in
Appendix B.
To Next Page
Loading...
