NETGEAR RangeMax Wireless PCI Adapter WPN311 User Manual
2-13
v3.0, January 2007
Setting up WEP Encryption Security
Follow the steps below to configure WEP Encryption Security.
1. Run the WPN311 Smart Wizard.
a. Make sure the WPN311 software is installed and the WPN311 Wireless PCI Adapter is
installed in a PCI slot in your computer.
b. Use the icon to open the Smart Wizard. The Settings tab page opens:
2. Configure the Security settings.
a. In the Profile box, select the profile or type in a profile name.
b. In the Network Name (SSID) field select the network, or enter the SSID.
c. In the Security section, select WEP.
3. Select the WEP encryption strength you will use:
• 64-bit WEP data encryption
• 128-bit WEP data encryption
Figure 2-9
Note: You will not get a wireless network connection unless the SSID entered exactly
matches the SSID used by the access point.
To Next Page
Loading...
