NETGEAR WG311v3 Reference Manual

Reference Manual for the NETGEAR 802.11g Wireless PCI Adapter WG311v3
Basic Setup 2-3
Your NETGEAR 802.11g Wireless PCI Adapter WG311v3 factory default basic settings are:
• Network Name Service Set Identification (SSID): ANY — a special name which indicates the
first available network will be used
Note: In order for the WG311v3 Wireless PCI Adapter to communicate with a wireless access
point or wireless adapter, all devices must be configured with the same wireless network name
(SSID).
• Network Mode (Infrastructure or Ad-Hoc): Infrastructure
• Data security WEP encryption: Disabled
The section below provides instructions for setting up the NETGEAR 802.11g Wireless PCI
Adapter WG311v3 for basic wireless connectivity to an access point. The procedures provide
step-by-step installation instructions for Windows PCs. Use the procedure that corresponds to the
version of Windows you are using.
Basic Installation Instructions
Use the procedure below that corresponds to the version of Windows you are using.

NETGEAR WG311v3 Specifications

General

Brand	NETGEAR
Model	WG311v3
Category	PCI Card
Language	English