NETGEAR WG311v3 - To Configure WEP Encryption Security

Reference Manual for the NETGEAR 802.11g Wireless PCI Adapter WG311v3
Configuration 3-9
To Configure WEP Encryption Security
Following the steps below to configure WEP Encryption Security.
1. Run the WG311v3 Configuration Utility.
Click the WG311v3 icon
in the Windows system tray and the Settings tab page opens
Figure 3-5: Settings tab page
2. Configure the Security settings.
a. Select the Use WEP Encryption check box.
b. Enter the SSID. This is also called the Wireless Network Name.
Note: You will not get a wireless network connection unless the network SSID matches
exactly what is configured in the access point.
Tip: You can click the Networks tab to view a list of the available wireless networks and
their SSIDs at your location.
3. Save your settings in a Profile.
a. Type a descriptive name for the Profile name.
b. Click Save Profile. All the configuration settings are saved in this profile.
c. Click Apply.
d. Click Close to exit the wizard.