NETGEAR WN2500RP

Extender Network Settings
21
Universal Dual Band WiFi Range Extender WN2500RP
• IP Subnet Mask. The IP subnet mask associated with the LAN IP address of the
extender. The default is 255.255.255.0.
• Gateway IP Address
. The IP address of the wireless network gateway.
• Domain Name Server. The IP address of the Domain Name Server (DNS) of the
wireless network.
Extender Wireless Settings
• Name (SSID). The name (SSID) of the wireless network.
• Region. The location where the extender is operating.
•
Channel. The channel of the wireless network.
•
Wireless AP. On or Of
f.
• Broadcast Name. On or Off.
•
Wi-Fi Protected Setup. Configured.
Show Statistics
Scroll to the bottom of the Status screen, and click Show Statistics. The following screen
displays:
The screen shows statistics for the LAN (local), and wireless LAN (WLAN) ports. For each
port, the screen displays the following:
• Status. The status of the port.
• TxPkts. The number of packets transmitted on this port since reset or manual clear
.
• RxPkts. The number of packets transmitted on this port since reset or manual clear
.
• Collisions. The number of collisions on this port since reset or manual clear
.
• Tx B/s. The current line utilization—percentage of current bandwidth used on this port.
•
Rx B/s. The average line utilization for this port.
•
Up Time.
The time elapsed since the last power cycle or reset.
• Poll Interval. Specify the poll interval frequency. If you change this value, click Set
Interval
so that your change takes effect.