NETGEAR WN3000RPv3 Quick Start

5
Use the Extender in Extender Mode
In extender mode, the extender repeats the signals from an existing WiFi
router or access point. Place the extender, apply power, and connect it to
your WiFi network.
Place the Extender and Apply Power
1. Place your extender in the same room as your WiFi router.
Proximity to the WiFi router is required only during the initial setup
process.
2. Plug the extender into an electrical outlet.
Wait for the Power LED to light green.
3. If the Power LED does not light, press the Power On/Off button on
the extender.
Connect to an Existing WiFi Network
To extend the range of your WiFi network, you must connect the extender
to your existing WiFi network. You can do this in one of two ways:
• Connect with WPS. For more information, see Connect with WPS on
page 6.
• Connect with web browser setup. For more information, see
Connect with Web Browser Setup on page 8.

NETGEAR WN3000RPv3 Specifications

General

WiFi Technology	802.11n
WiFi Performance	N300 (300 Mbps)
WiFi Band	2.4GHz
Number of Ethernet Ports	1
Ethernet Port Type	10/100 Mbps
Security	WEP, WPA/WPA2-PSK (Wi-Fi Protected Access)
LED Indicators	Power
Button Controls	WPS