NETGEAR WN3000RPv3 Quick Start

8
a. Leave your computer or WiFi device in the area with a poor router
WiFi signal and return to the extender.
b. Check the Client Link LED on the extender:
• If the Client Link LED is solid green or amber, your extended
WiFi network reaches the area with a poor router WiFi signal
and your network setup is complete.
• If the Client Link LED is red, your extended WiFi network
does not reach the area with a poor router WiFi signal.
You must move the computer or WiFi device closer to the
extender until the Client Link LED turns solid green or amber.
Connect with Web Browser Setup
1. Use a WiFi network manager on a computer or mobile device to find
and connect to the extender WiFi network NETGEAR_EXT.
Aer the connection with the computer or WiFi device is established,
the Client Link LED lights.
2. Launch a web browser.
3. Enter www.mywifiext.net in the address field of the browser.
The New Extender Setup page displays.
4. Click the NEW EXTENDER SETUP button.
The Create Account page displays.

NETGEAR WN3000RPv3 Specifications

General

WiFi Technology	802.11n
WiFi Performance	N300 (300 Mbps)
WiFi Band	2.4GHz
Number of Ethernet Ports	1
Ethernet Port Type	10/100 Mbps
Security	WEP, WPA/WPA2-PSK (Wi-Fi Protected Access)
LED Indicators	Power
Button Controls	WPS