EasyManuals Logo

NETGEAR WN3100RP Installation

NETGEAR WN3100RP
20 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #6 background imageLoading...
Page #6 background image
6
Install the WiFi Extender
Place the extender, apply power, and connect it to your WiFi network.
Place the Extender and Apply Power
1. Place your extender in the same room as your WiFi router.
Proximity to the WiFi router is required only during the initial setup
process.
2. Plug the extender into an electrical outlet.
The Power LED lights green. If the Power LED does not light,
slide the Device On/O switch on the side of the extender to the On
position.
Connect to an Existing WiFi Network
To extend the range of your WiFi network, you must connect the extender
to your existing WiFi network. You can do this in one of two ways:
• Connect with WPS. For more information, see Connect with WPS on
page 7
.
• Connect with web browser setup. For more information, see
Connect with Web Browser Setup on page 9.

Other manuals for NETGEAR WN3100RP

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NETGEAR WN3100RP and is the answer not in the manual?

NETGEAR WN3100RP Specifications

General IconGeneral
TypeNetwork transmitter
Maximum transfer distance- m
Windows operating systems supportedYes
Product colorWhite
Bandwidth2.4 GHz
Cabling technology10/100Base-T(X)
Security algorithmsWEP, WPA2-PSK, WPS
Networking standardsIEEE 802.11b, IEEE 802.11g, IEEE 802.11n
Ethernet LAN (RJ-45) ports1
Weight and Dimensions IconWeight and Dimensions
Depth32.5 mm
Width55 mm
Height114 mm
Weight175 g

Related product manuals