Getting Started
9
Wireless N150 Access Point WN604
Rear Panel
Power
Power
LAN ports 1–4 Reset Antenna
On/Off
Figure 2. WN604 rear panel
During set up, use an Ethernet RJ-45 port to connect a computer. After initial set up, use an
Ethernet port to connect to an Ethernet LAN through a device such as a hub, switch, router,
or PoE switch.
The Reset button has two functions:
• Reboot. W
hen pressed and released quickly, the access point restarts.
• Reset
to Factory Defaults. This button can also be used to clear all data and restore all
settings to the factory default values. See Factory Default Settings on p
age 6.
To Next Page
Loading...
