NETGEAR genie Basic Settings
28
N600 Wireless Dual Band Gigabit Router WNDR3700v4
Read Access and Write Access. Shows the permissions and access controls on the
network folder: All – no password (the default) allows all users to access the network
folder. The user name (account name) for All – no password is guest. The password for
admin is the same one that you use to log in to the router. By default, it is password.
Folder Name. Full path of the network folder.
Volume Name. Volume name from the USB storage device.
Total Space and Free Space. Shows the current utilization of the storage device.
• Edit. Click the Edit button to edit the Available Network Folders settings.
• Safely Remove USB Drive. Safely remove the USB device attached to your router.
You can click Refresh to update this screen. For more information about USB storage, see
Chapter 5, Storage.
Basic Wireless Settings
The Wireless Settings screen lets you view or configure the wireless network setup.
The router comes with preset security. This means that the Wi-Fi network name (SSID),
network key (password), and security option (encryption protocol) are preset in the factory.
You can find the preset SSID and password on the bottom of the unit.
Note: The preset SSID and password are uniquely generated for every
device to protect and maximize your wireless security.
To view or change basic wireless settings:
NETGEAR recommends that you do not change your preset security settings. If you change
your preset security settings, make a note of the new settings and store it in a safe place
where you can easily find it.
If you use a wireless computer to change the wireless network name (SSID) or other wireless
security settings, you are disconnected when you click Apply. To avoid this problem, use a
computer with a wired connection to access the router.
To Next Page
Loading...
Need help?
General
