Manage Your Network
128
N900 WiFi Router
• A metric value of 1 works because the ISDN router is on the LAN.
• The Private check box is selected only as a precautionary security measure in case RIP
is activated.
Set Up a Static Route
To set up a static route:
1. Launch a web browser from a computer or wireless device that is connected to the
network.
2. T
ype http://www.routerlogin.net or http://www.routerlogin.com.
A login screen displays.
3. Enter the user name and password.
The user name is admin.
The default password is password. The user name and
password are case-sensitive.
The BASIC Home screen displays.
4. Select ADV
ANCED > Advanced Setup > Static Routes.
The Static Routes screen displays.
5. Click the Add button.
6. In the Route Name field, type a name for this static route (for identification purposes only).
7. T
o limit access to the LAN only, select the Private check box.
If the Private check box is selected, the static route is not reported in RIP
.
8. T
o make this route effective, select the Active check box.
9. T
ype the IP address of the final destination.
10. T
ype the IP subnet mask for this destination.
If the destination is a single host, type 255.255.255.255.
11. T
ype the gateway IP address, which must be on the same LAN segment as the router.
12. T
ype a number from 1 through 15 as the metric value.
This value represents the number of routers between your network and the destination.
Usually
, a setting of 2 or 3 works, but if this is a direct connection, set it to 1.
To Next Page
Loading...
