3DHD Home Theater Adapter WNHD3004 User Manual
2-2 Setting Up Your Wireless Network
v1.0, November 2010
Access Point Mode WPS Setup
These instructions will guide you through connecting the WNHD3004 to a router. Then, you will
connect wirelessly using WPS technology.
1. Connect the Ethernet cable from a LAN port on your existing
router or gateway to an Ethernet port on the WNHD3004.
2. Connect the power adapter to the unit. Verify that the power light
is on.
You are finished with setting up the access point.
Figure 2-1
To Next Page
Loading...
