Using NETGEAR genie
28
Universal WiFi Extender - Powerline Edition (XAVN2001)
Note: If your computer is not connected locally (with an Ethernet cable) to
the device that you want to configure, you must enter the device
password. The device password is printed on the product label on
the back of the device.
5. Click the Apply Security to Selected Devices button.
When the encryption key is set, a message displays indicat
ing that the operation was
successful.
6. Click OK.
Reset a Device to Factory Default Settings
This option resets the encryption key of a Powerline device to the factory default key,
HomePlugAV.
Note: If your Powerline network uses a private encryption key, resetting a
Powerline device to its factory default settings disconnects the
device from the network. To avoid disconnecting your computer from
the network, reset all other Powerline devices on the network before
you reset the device that is connected to your computer.
To reset a device to its factory default settings:
1. On
the Powerline Utility screen, right-click the icon of the device.
2. On the pop-up menu that
displays, select Factory Reset.
A pop-up screen displays advising you that connectivity will be temporarily lost while the
device is being reset.
3. Click OK.
A message displays asking you to confirm the reset.
4. Click OK
to reset the device. A message indicates whether the operation succeeded.
To Next Page
Loading...
