Drainage
There are two ways of removing water collected by the unit.
A. Manual Drainage: Empty the water tank manually.
B. Continuous Drainage: Use gravity to drain water by attaching a
drain hose.
Manual Drainage
The water tank will fill up and shut the unit down once it is full. It
will only run again once you empty the water tank and re-install it.
1. When the water tank is full, the machine will buzz 5 times and
the ‘Water Tank Full’ indicator light will be on.
2. Press the ‘Stand-By’ button to turn off the unit.
3. Pull on the water tank and slide it out of the body of the
dehumidifier.
4. Empty the water into an area with a drain or outside.
5. Clean the inside of the tank as well as the outside.
6. Replace the empty tank back into the unit.
7. Press the power button to resume operation.
8. If the ‘Water Tank Full’ light does not turn off, check that the
float is correctly in place.
To Next Page
