EasyManua.ls Logo

netta OL20-BD068A - Operating the Device Safely; Operating the Product

netta OL20-BD068A
28 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
WARNING
Install the unit in rooms which exceed 4m².
OPERATING THE DEVICE SAFELY
Check the device after unpacking for any damages or
scratches on it.
Operate this unit in an ambient temperature from 5°C to
35°C.
Do not use in the outdoors. This dehumidifier is intended for
indoor residential applications only.
Do not operate in close proximity to walls, curtains, or other
objects that may block inlet and outlet.
Keep the air inlet and outlet free of obstacles.
Adjusting the wind deflector in the upward direction prior to
start up.
If tipped more than 45°, allow the unit to set upright for at
least 24 hours before start up.
Keep doors and windows close for better energy saving.
Do not operate or store the unit in direct sunlight or rain.
It is normal for air outlet to feel warm to touch after
continuous operation on hot days.
Empty the water tank before moving the device.
Make sure the water tank is correctly fitted otherwise the unit
will not operate properly.
The dehumidifier starts up in the mode selected when the
unit was last used.
The dehumidifier starts dehumidifying if the room humidity is
3% higher than the selected humidity.
There is a protective 3-minutes time delay of the compressor.
Wait 3 minutes for the dehumidifier to resume
dehumidification.
Operating the Product