Drainage
There are two ways of removal collected water produced by the
unit.
A. Manual draining: Empty water tank by manual.
B. Continuous draining: Use gravity to drain condensate water by
attaching a drain hose.
Emptying the Water Tank
The built-in water tank will fill up and shut the unit down once it is
full. It will run again once you empty the water tank and re-install
it properly.
1) When the tank is full, The machine will buzz for 5 times and
the “Water Tank Full” indicator light will light up.
2) Press the POWER button to turn off the unit.
3) Pull on the water tank and simply slide out of the body of the
dehumidifier.
4) Empty the water into an area with a drain or outside.
5) Clean the inside of the tank as well as the outside.
6) Replace the empty tank back into the unit.
7) Press the POWER button to resume operating.
8) If the Water Full light does not extinguish, check that the float
is correctly in place.
Operating the Product
Drainage (continued)
To Next Page
