1. Do not discard the magnets and plastic rivets in the tank.
Otherwise, the dehumidifier cannot be started, or the machine will
not automatically stop working when the water tank is full, and the
condensed water overflow will damage the floor of the room.
2. Please make sure to clean the condensed water in the tank and
put the tank in the original position
3. If the water tank is dirty, please rinse it with clean water. Avoid
using detergents, steel wire balls, chemical dust removers, diesel,
benzene, diluents or other solvents. Otherwise, it can damage the
tank and cause leaks.
4. Put the water tank in its original position. Otherwise, the
indicator light will always be red and the machine cannot start
working again.
Operating the Product
Drainage (continued)
Continuous Drainage
For continuous operation or unattended dehumidification, please
connect the attached drain hose to the unit. Condensate water can
be automatically flow into a bucket or drain by gravity.
To Next Page
