Quick Setup Guide
How to start:
1)Connect scanner with your device via USB cable.
2)Setup keyboard language: If you use US keyboard, it's plug and play.
If you use other type of keyboard, scan command barcode of the
keyboard from this manual. For more information please refer to"key-
board language".
3) Locate cursor on place where you want the scanner to output the data.
Once you finished above steps you scan start to scan.
Programming Code
NetumScan barcode scanners are factory programmed for the most
common terminal and communications settings. If you need to change
these
settings ,programming is accomplished by scanning the bar codes in this
guide. An asterisk (*) next to an option indicates the default setting.
Important Notes:
This scanner has big scanning range, make sure you cover the codes
closed to the one that you want to scan so they will not be scanned by
accident.
- 1 -
To Next Page
Loading...
Need help?
General
