Need help?Do you have a question about the Netum W3 and is the answer not in the manual?
Configure scanner settings by scanning programming barcodes.
Set scanner language to match host keyboard for proper data input.
Manual scanning mode activated by pressing the trigger button.
Automatic scanning mode activated when an object is detected.
Define data termination characters like CR, CRLF, or TAB.
Control audible feedback for scan success or failure.
Reset the scanner to its original factory default settings.
Enable or disable 2 or 5 digit add-on codes for barcodes.
Manage the Interleaved 2 of 5 barcode symbology.
Manage the MSI barcode symbology.
Control the Plessey barcode symbology.
Manage the Code 32 barcode symbology.
Control the GS1 DataBar Limited (RSS Limited) barcode.
Manage the GS1 DataBar Omnidirectional (RSS Omnidirectional) barcode.
Configure scanner for standard or reversed 1D barcode reading.
Troubleshooting common problems with barcode scanning.
Addressing issues related to carriage return/line feed in data transmission.
Guidance on adding or removing data suffixes from scanned output.
Resolving garbled data when using non-English keyboard layouts.
Provides phone, email, and physical address for support.
To Next Page
General
