1
Quick Setup Guide
This is 1D&2D plug and play model if you use a US keyboard. If you use
other type of keyboard, plug the USB cable on your device , setup keyboard
language before you use it. (refer to below Keyboard Language Type) after
that the scanner can start to work. If you want to do other con�igurations
please refer to below programming barcodes.
Barcode Programming
Netum barcode scanners are factory programmed for the most common
terminal and communications settings. If you need to change these settings,
programming is accomplished by scanning the bar codes in this guide. An
asterisk (*) next to an option indicates the default setting.
Keyboard Language
In order to let scanner upload the codes in a correct way, you have to set the
keyboard language.
For example
If you use French Keyboard, scan below barcode of “French keyboard” then
scanner will upload barcodes according to France keyboard layout.
American Keyboard is set by default, if you use a US keyboard you can skip
this step.
American Keyboard*
0005000
0005014
Portugal Keyboard