3.2 Printer Operation
• Switch on: Ensure the adapter properly connected with the printer,
press the switch on the “1”position, printer turns on.
• Switch off: Press the switch on the other side “O”.
• Paper Feeding: Press “ FEED” button when powers on, paper will
keep running & stop to run when loosen this button.
• Self Printing Test : Switch off the printer then press “FEED” button
and do not release. Press the “POWER” button at the same time till the
“ ERROR” indicator on, release the button about 1 second after the
“ERROR” indicator off. Then we can read the current setting from the
test page.
• Hexadecimal printing: Power off the printer, press “FEED” button &
do not release, press “POWER” button at the same time until the
“ ERROR” indicator on, release the “FEED” button about 3 seconds after
the “ ERROR” indicator off ; The way to quit Hexadecimal printing model
is just press “ FEED” button by three times.
• Aging model printing: power off the printer, press “ FEED” and hold it
until the “ Error” indicators turn on and off; repeat this operating if we
wish to exit the aging mode.
DIP Switches and Instruction
To Next Page
Loading...