(Note: The Bluetooth device will automatically assign a COM
port.)
8: Now if you want to test if the printer is OK to print, you could
use a com tool , and send printed data to Outgoing COM
port( just as above image shown: COM5).
(Com tool setting is 9600,N,8,1.)
When using the Ethernet to printing need to be modified Mac, IP, subnet mask,
gateway, web printer function can be used to modify, the main changes as
follows:
1, connect the power, using a crossover cable to connect your PC to the printer,
such as a router connection, printer and computer are connected to the router.
2, hold down the "FEED" button while turning the printer power switch, and
when "PAPER OUT" indicator light, release the "FEED" button, the printer
prints a self-test page, get on the self-test page, such as "Image I" in the red
box after restarting the printer within the relevant information, as shown below:
Image 6.1
To Next Page
Loading...